Note: The MCS calculator is only available when designing a system within the UK. If used outside of the UK it will throw an error.
OpenSolar's MCS Calculator follows the MCS standards in calculating solar PV output as defined in MIS 3002 (The Solar PV Standard (Installation)). It also follows the methodology in calculating self-consumption with and without energy storage as defined in MGD 003 (Determining the Electrical Self-Consumption of Domestic Solar Photovoltaic (PV) Installations with and without Electrical Energy Storage).
How to Set the MCS Calculator as the Default?
To set the MCS PV Output Calculator to be the default calculator please go to Control > Design & Hardware > Setbacks & Design Settings > Simulation Settings and select MCS (UK Only) option under Energy Production Calculator.
How to Set the MCS Calculator for a specific project?
You can set to use the MCS PV Output Calculator within Studio under Advanced Settings > Energy Production Calculator.
How to add the MCS System Performance Summary to your Proposal?
You can add the MCS system performance summary table (Only if using the MCS Calculator) to your proposal template by the following steps:
Go to Control > Purchase Experience > Proposal Template and then click on of an existing proposal template (please create a new proposal template if you don't have one created already). You will then need to open up the Proposal Content section.
- Scroll down to the Disclaimers section in Proposal Content. Note: The placeholder for the MCS system performance summary table is only available within the Disclaimers section of the Proposal Template.
- You can add the placeholder for the MCS system performance summary under any Disclaimer section by clicking on the icon as shown in the image below.And then search for Compliance System Performance Table (If Applicable). It is recommended to either place it under System Performance or System Hardware Components to show the MCS table directly under System hardware section in MyEnergy.
- Save the proposal template and go to MyEnergy to see if the MCS system performance table has been applied. The MCS system performance table should look like the table shown below:
How do i set the Occupancy Archetype for MCS Self-consumption Calculations?
You can set the occupancy archetype in Projects > Electricity Usage. You will need to choose a usage source other than default as you set the occupancy archetype under Curve weekday. Each of the options for Curve Weekday maps to the 3 different occupancy archetype as defined in the table below:
Limitations of the MCS Self-consumption Calculations:
The MGD 003 is only applicable in a domestic context when:
- The total expected annual electricity generation from domestic solar PV system is less than 6000 kWh per year according to approved MCS calculations.
- The total annual domestic electricity consumption is between 1500 kWh and 6000 kWh per year.
- And the usable energy storage capacity is less than 15.1 kWh
If the any of these conditions are not met, the self-consumption will be calculated using OpenSolar's self-consumption calculations.
Note: MGD 003 defines the maximum self-consumption percentage as 95%. Hence when using the MCS calculator, the self-consumption will never exceed 95%.